advanced web statistics

How To Start A Briggs And Stratton Pressure Washer


Starting a Briggs and Stratton pressure washer can be a daunting task for those who have never done it before. This guide will walk you through the steps and provide you with the knowledge you need to get your Briggs and Stratton pressure washer up and running.

The first step is to make sure that the pressure washer is filled with the correct amount of fresh oil. Check the owner’s manual for the correct type of oil to use. After filling the pressure washer with oil, close the oil fill cap and make sure it is securely tightened.

Next, make sure the fuel tank is filled with gasoline. If you are using a gasoline-powered pressure washer, you will need to use the correct fuel type. Check the owner’s manual to make sure you are using the correct fuel.

Now that the fuel and oil are filled, it’s time to start the Briggs and Stratton pressure washer. Begin by turning the engine switch to the “on” position. Next, press the primer bulb several times until fuel begins to flow from the primer bulb. This will ensure that the engine has the correct amount of fuel in the system.

The next step is to pull the starter cord. Pull the starter cord slowly and steadily until the engine begins to run. Once the engine is running, you can adjust the pressure and water flow as needed.

Finally, the last step is to check the oil level. Check the oil level periodically to ensure the oil is at the correct level. If the oil level is low, add oil as necessary.

By following these steps, you should have your Briggs and Stratton pressure washer up and running in no time. If you have any further questions or concerns, consult the owner’s manual or contact a professional for assistance.