advanced web statistics

How To Change The String On A Greenworks Weed Eater


A Greenworks weed eater is a common tool used by homeowners for trimming grass and weeds. Over time, the string in the weed eater will become frayed or broken, and it will need to be replaced. Changing the string on a Greenworks weed eater is a relatively easy process that can be done in just a few steps.

Before beginning, make sure you have the right trimmer line available for your particular model of Greenworks weed eater. Replacement trimmer line can be found at most hardware stores.

Follow these steps to change the trimmer line on a Greenworks weed eater:

  • Turn off the weed eater and unplug it from the electrical outlet.
  • Hold the trimmer head in one hand and use a flathead screwdriver to loosen the screws located on the outside of the head.
  • Remove the spool from the trimmer head and cut off the remaining trimmer line.
  • Wind the new trimmer line around the spool in the same direction as the arrow on the side of the spool.
  • Put the spool back in the trimmer head and tighten the screws.
  • Plug the weed eater back in and turn it on.

It is important to note that the correct trimmer line must be used for the specific model of Greenworks weed eater. If the wrong type of trimmer line is used, it may not fit properly or may not be strong enough to withstand the force of the weed eater. Additionally, the trimmer line should be wound around the spool tightly, but not too tightly, as this could cause it to break.

By following these steps, you can easily change the trimmer line on a Greenworks weed eater. This process should only take a few minutes and can help ensure that your weed eater is functioning properly.